Fixed Beam Anchor Vertical – Horizontal Beam Flange for 4″ x 14″ – 1/4” to 1″ Thickness

General Info

• The Ultra-Safe, Inc. beam anchor adjusts to fit 4 inch to 14 inch steel beams up to 1 1/2” thickness.
• Manufactured with grade 8 hardware and slip proof notches for easy installation.
• Ensure compatibility between anchor and connecting hardware.
• When mounting anchorage, base must be flush with mounting surface. Also, when mounting on a vertical surface, the anchor ring must be perpendicular to the ground plane.
• Mounting surface must have a minimum tensile capacity of 10,000 lbs. (10k).
• Clamp is suitable for use as termination or intermediate (pass thru).

INSTALLATION INSTRUCTIONS

1. Center clamp on column flange
2. Move clamping tabs in as close to the flanges as possible.
3. Seat heel of clamping tabs in nearest slip resistant notch directly opposite of each other
4. Tighten tab bolt nuts, as tight as possible with wrench (Approximately 100ft. lbs torque)

Flange: 1 1/2”
Max Weight: 14 lbs.
Materials: Carbon Steel
Manufactured in: U.S.A.
Minimum Tensile: 10,000 lbs. (10k) @90°
Meets or Exceeds ANSI Z359.7-2011

WARNING: It is the user’s responsibility to become familiar with all rules and regulations regarding the use of all fall protection products, including safety beam anchors. Ultra-Safe, Inc. is not responsible for accidents that may occur as a result of improper installation. Do not exceed 45 degree load angle on eye. Clamp should be taken out of service and replaced if any visual distortion should occur.